LAISHA
Open Laisha

Calibrate your knapsack sprayer in 5 minutes

Short · · 47 s

Spray 100 m² with water at normal pace: 4 L used = 400 L/ha. A 16 L knapsack then covers 400 m², so a product at 1.0 L/ha needs 40 mL per tank. Always use the label rate.

Sprayer calibration (worked) →

Subscribe on YouTube

Why a water test beats guessing

Two people carrying the same knapsack can apply very different volumes, because output depends on the nozzle tip, the pumping rhythm, how high the lance is held and how fast the operator walks. Field surveys of hand spraying in many countries have found real rates far from the intended ones, often with product measured by the capful. A short test with clean water turns the sprayer and the person using it into a known rate, so the product goes on at the dose printed on the label.

Setting up a fair test

Mark a rectangle in the crop you will treat, or on ground with similar footing, for example 5 by 10 metres. Fill the tank to a marked level, pump up to working pressure and spray the plot exactly as you would spray the crop: same tip, same swath width, same height above the target, same pace. Then top the tank back up to the mark from a measuring jug and note how much went in.

Repeat the run and average the two. If they differ by more than about 10 per cent, the pumping or walking is inconsistent and needs practice. Check the tip separately by catching its spray for one minute; a worn or damaged tip that delivers clearly more than a new one should be replaced.

From test result to tank mix

Say the 50 square metre plot took 1.5 litres. A hectare is 10,000 square metres, 200 times the plot, so the rate is 1.5 × 200 = 300 litres per hectare. A 15-litre tank then covers 15 ÷ 300 = 0.05 hectare, or 500 square metres. If the label rate is 2 litres of product per hectare, each tank takes 2 × 0.05 = 0.1 litre, that is 100 millilitres. A powder used at 500 grams per hectare would need 25 grams per tank.

Some labels, especially for vegetables and fruit trees, state a concentration instead, such as millilitres per 10 litres of water; follow the basis the label uses. If your water rate falls outside the volume range on the label, change the tip or your pace, not the amount of product.

Keeping the rate steady in the field

In a lever-operated sprayer, pressure rises and falls with each stroke, changing both flow and droplet size. Pump at a steady rhythm, or fit a constant-flow or pressure-regulating valve at the lance. Hold the tip at a fixed height and walk at an even speed; counting steps or following a marked string helps. Overlap passes only by the width the spray pattern needs. For row crops, banding over the row uses less water than covering the whole surface, so calibrate in the way you will actually spray.

Safety and when to recalibrate

Use water alone for calibration, but wear the protective equipment the label requires whenever you mix or apply product, and wash hands and face before eating or smoking. Check for leaks at the lid, pump seal and lance, since a leaking knapsack soaks the operator's back and legs. Repeat the test whenever you change tip, operator, crop height or terrain, and at the start of each season. Rinse empty containers three times, adding the rinse water to the tank, and dispose of them as local rules require. Do not spray in strong wind, before heavy rain or close to wells, streams and ponds.

Sources: FAO, Guidelines on good practice for ground application of pesticides (2001) · Matthews GA, Bateman R, Miller P, Pesticide Application Methods, 4th ed., Wiley-Blackwell (2014)

Transcript

How much does your knapsack sprayer really put on a hectare?

Most people guess.

Here is how to know in five minutes.

Mark out ten metres by ten metres: one hundred square metres.

Spray it with clean water, at your normal walking pace and pressure, and measure the water you used.

Four litres means four hundred litres per hectare.

Then a sixteen-litre knapsack covers four hundred square metres. So a product used at one litre per hectare needs forty millilitres per tank.

Always take the rate from the label for your crop.

The full sprayer calibration guide, with boom sprayers, is in our long video and at laisha.ai.

Last updated · How Laisha writes and checks its pages · Report a mistake

Ask Laisha about this

Opens Laisha's chat with your question ready to send. Sign in or start free.

Go further with Laisha Smarter

US$10 a month · one price worldwide · cancel any time

  • Ask Laisha about what you watched — up to 1,000 questions a month
  • Your own crop calendar and pest alerts
  • Every calculator and tool
10 days free for every new account, no card.